User's Manual

InterSense Doc. No. 072-00105-0I07 Rev. 4.2
IS-900 User Guide Page 117 of 177
10.4.1. Wireless Configuration window
The window below lists the wireless status and configuration for each processor port.
Normal Mode Determines wireless communication by device Link IDs
Anonymous Mode Determines wireless communication by wireless channel, and ignores
Link IDs
Port Port of the IS-900 Processor.
Configured Channel The channel that the connected Base Receiver Module is configured to.
No two Base Receiver Modules can be configured to the same channel /
band pair (however, the same channel is permitted if using a 900 MHz
and 2.4 GHz receiver, since each channel represents a different
frequency).
Reported Channel The channel that the connected Base Receiver Module is currently
configured for (0-15 for 2.4 GHz, 1-10 for 900 MHz).
Configured Link ID The link ID that is assigned to the receiver. Each wireless tracker has a
link ID associated with it when it is shipped, based on the lower 5 digits
of the internal device serial number. This 4-5 digit number can be found
on a label on your tracker (or its cable for trackers with cables).
Reported Link ID The link ID that is currently associated to the Base Receiver Module.
Status Port status. Any ports with a status of “no receiver” did not have a Base
Receiver Module detected, and cannot be configured.
Radio 900 MHz or 2.4 GHz band; both may be used simultaneously.