User's Manual
Table Of Contents
- Table of Contents
- Table of Figures
- 1. System Description
- 1.1. IS-900 Configuration
- 1.2. IS-900 SimTracker & VETracker Processor
- 1.3. SoniStrips, SoniFrame, SoniWing & SoniPod acoustic pulse transmitters
- 1.4. Acoustic Constellation Mounting Considerations
- 1.5. Tracking Station Description
- 1.6. IS-900 Cables, Connectors, Adaptors, Power Boosters and Wireless Radios
- 1.7. IS-900 Support CD
- 2. Specifications
- 3. Installation and Set-up
- 4. Interface Communication Protocol
- 5. LCD Status & Settings Screen
- 6. Appendix A – Frequently Asked Questions
- 7. Appendix B – Troubleshooting & Tips
- 8. Appendix C – Health & Safety Warnings with Tracker Use Guidelines
- 9. Appendix D – Care & Maintenance
- 10. Appendix E – ISDEMO Reference
- 11. Appendix F – GENLOCK Synchronization
- 12. Appendix G – Developers Instructions
- 13. Appendix H – Interface Protocol Commands – Quick Reference
InterSense Doc. No. 072-00105-0I07 Rev. 4.2
IS-900 User Guide Page 5 of 177
Warnings and Precautionary Statements
Any changes or modifications to the IS-900 SimTracker/VETracker,
MicroTrax Tracking Devices and other components of the IS-900 System
not expressly approved by InterSense will void the warranty and any
regulatory compliance issued for the system. This could also void the
user’s authority to operate the equipment.
MicroTrax device microphones are susceptible to ESD and may require
power cycling to recover from communication failure.
Do not drop or otherwise shock the tracking devices for they can be
permanently damaged.
Do not bend, twist, pull strongly or tamper in any way with any part of the
cabling.
Take care to avoid electric shocks. Do not plug-in or unplug the power
cable with wet hands.
Please see Appendix C for Health and Safety warnings and guidelines
Wireless Devices
This device contains a Lithium Ion battery that should only be used with the following warnings
and precautions.
• Avoid short circuits
• Do not dispose of the battery in fire
• Do not heat the batteries above 60°C
• Do not solder directly to the batteries
• Do not charge above 4.2V
• Do not charge below 0°C or above 45°C
• Do not discharge below 2.7V
• Do not discharge below 20°C or above 60°C
• Do not insert the batteries in reverse polarity
Warning: Fire, Explosion, and Severe Burn Hazard