User's Manual

InterSense Doc. No. 072-00105-0I07 Rev. 4.2
IS-900 User Guide Page 8 of 177
Do not bend, twist, pull strongly or tamper in any way with any part of the
IS-900 cabling.
Take care to avoid electric shocks. Do not plug-in or unplug the power cable
with wet hands.
During normal operation, the user should not make contact with the metal
surfaces, including the microphone housings and the connector hood, of the
tracking stations. Such contact could result in invalid data or a tracker reset.
Please see the section titled Health and Safety Warnings and Guidelines
Radio System Information
These devices contain a commercially available 900 MHz or 2.4 GHz non-frequency hopping
wireless data communication link.
The wireless link is intended for use in normal commercial applications. Applications requiring
extended temperature range or unusual environmental requirements such as military, medical
life-support or life-sustaining equipment are specifically not recommended without additional
testing for such applications.
The following devices:
• IS-900 MicroTrax Wireless Transmitter
o part number 100-91000-EWTX: 2.4 GHz
o part number 100-91900-EWTX: 900 MHz
These devices, with their antenna, comply with FCC’s RF radiation exposure limits set forth for an
uncontrolled environment. To maintain compliance, they must not be co-located or operate in
conjunction with any other antenna or transmitter.
Complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. These devices may not cause harmful interference
2. These devices must accept any interference received, including interference that may
cause undesired operation.