User manual

With this wiring option, you can connect the bass directly using a two-wire cable (wires 1+/1–).
If you are using four-wire cables, you can use heads that receive their signal via wires 2+/ 2–
and loop wires 1+/ 1– through. The bass is connected to wires 1+/1– and loops wires 2+/ 2–
through. The order in which the speakers are wired doesn't matter. Never fall below the min‐
imum load impedance, though.
The adjoining gure shows the pin assignment of the lockable NL4 panel connectors.NL4 mounting connectors for
speaker connections
Installation
passive speaker
16