Installation & Assembly

 Apply top half of decal to
wall gently smoothing it down.
 Use a blowdryer to heat the decal slightly.
This will soften the decal and allow it to fully
conform to the slight texture of a wall. Use a wet
rag and apply pressure to entire decal. This
makes the trasfer tape less tacky so it will let go of
the decal.
 Flip decal up and remove remaining wax
paper backing. Gently apply the rest of the decal
to the wall working your way from the middle down
and out as you go. It helps to have someone hold
the unapplied portion of the decal away from the
wall as you work your way down.
 Slowly peel away transfer tape layer.
Take your time and make sure the decal
remains stuck to the wall.
 Repeat process for each part of your
decal. Smaller pieces will come without
transfer tape so you can more easily apply
them just like a sticker.
 Tape each decal to your wall to get a
feel for the look and positioning of each decal
before starting application.
*Once applied decals are not repositionable*
 Take decal o the wall and lay it face down
on at surface. Peel top of paper backing
away then cut and remove it.
 Cut each piece of your decal out. Many
of our decals come as sheets and each decal
needs to be cut out and applied seperately.
1 2
3 4 5
6
7
8
Wall Decal Application Instructions
BEFORE YOU BEGIN: Read through entire instructions once before starting
* If walls are freshly painted, wait 3 weeks before applying decals *
YOU’LL NEED: Decal, masking tape, scissors, washcloth, and a blowdryer.
Your Decal comes in 3 layers:
A - Transfer Tape
B - Cut Decal
C - Paper Backing
A
B
C