Installation Guide

ManualsBrandsThe Energy Guardian ManualsAccessoriesR-38 Attic Stair Insulation Cover and Air Sealing Kit for Pull Down Ladders with IM 27 in. x 55 in. x 10 in.

The Energy Guardian®

Pulldown Ladder Cover

Installation Instructions

For Support, Please Contact ESS Energy Products at: info@essnrg.com or 1-877-377-4674

7. ADHESIVE

The Energy Guardian® Speed ADHESIVE is essential for

bonding components together. If ADHESIVE is included,

cut a small corner off the bottom of the pouch and apply

where needed. Apply in a thin bead or in a spot the size of a

nickel for maximum adhesion. Set time is approximately 20

minutes. Keep at room temperature prior to use (70°F is ide-

al). ADHESIVE may be also sold separately.

●

1. LID

Note: Your kit will have either a ONE PIECE LID or a TWO PIECE LID

3. SHORT FRAME SECTION

(x2)

5. HANDLE

(x3)

4. L-BRACKET (x2)

SCREWS (x4)

6. PIN (x6)

Cut small corner off

pouch to create this

COMPONENT LIST:

Please check that all components are included and not damaged by shipping. If you have missing or damaged

components, STOP and call Customer Service at 1-877-377-4674 before returning the kit.

2. LONG FRAME SECTIONS

Note: Your kit will have either ONE PIECE or TWO PIECE LONG FRAME SECTIONS

Summary of content (4 pages)

PAGE 1
The Energy Guardian® Pulldown Ladder Cover Installation Instructions COMPONENT LIST: Please check that all components are included and not damaged by shipping. If you have missing or damaged components, STOP and call Customer Service at 1-877-377-4674 before returning the kit. 1. LID Note: Your kit will have either a ONE PIECE LID or a TWO PIECE LID 2. LONG FRAME SECTIONS Note: Your kit will have either ONE PIECE or TWO PIECE LONG FRAME SECTIONS 3. SHORT FRAME SECTION (x2) 7. ADHESIVE 4.
PAGE 2
The Energy Guardian® Pulldown Ladder Cover Installation Instructions Please check that all components are included and not damaged by shipping. If you have missing or damaged components, STOP and call Customer Service at 1-877-377-4674 before returning the kit. TWO PIECE LID and LONG FRAME ASSEMBLY NOTE: If your kit has a ONE PIECE LID, skip to HANDLE INSTALLATION section below Glue Pattern 1. Lay two LID components and four LONG FRAME SECTIONS on a flat surface 2.
PAGE 3
FRAME ASSEMBLY 1. 2. 3. 4. Place LID down with lip of LID facing up. Label and HANDLES will be facing you (See Picture #8) Using LID as template, place 2 LONG FRAME SECTIONS on the LID.
PAGE 4
L-BRACKET ASSEMBLY 1. To ensure a snug fit of REMOVABLE SHORT FRAME SECTION, install L-BRACKET on outer side of both LONG FRAME SECTIONS even with REMOVABLE SHORT FRAME SECTION (See Picture #16) 2. Using SCREWS, secure L-BRACKET to floor of attic so vertical side of L-BRACKET is snug against the LONG FRAME SECTION (See Picture #17) 3.