Instructions / Assembly

ManualsBrandsThe Energy Guardian ManualsAccessoriesR-38 Attic Stair Insulation Cover and Air Sealing Kit for Pull Down Ladders with IM 27 in. x 55 in. x 10 in.

The Energy Guardian®

Pulldown Ladder Cover

Installation Instructions

Models: PS1, PS2, PT1 & PT2

For Support, Please Contact ESS Energy Products at: info@essnrg.com or 1-877-377-4674

7. ADHESIVE

The Energy Guardian® Speed ADHESIVE is essential for

bonding components together. If ADHESIVE is included,

cut a small corner off the bottom of the pouch and apply

where needed. Apply in a thin bead or in a spot the size of a

nickel for maximum adhesion. Set time is approximately 20

minutes. Keep at room temperature prior to use (70°F is ide-

al). ADHESIVE may be also sold separately.

●

1. LID

PS1 & PTI Models have ONE LID PS2 & PT2 Models have TWO LID HALVES

3. SHORT FRAME SECTION

(x2)

5. HANDLE

(x3)

4. L-BRACKET (x2)

SCREWS (x4)

6. PIN (x6)

Cut small corner off

pouch to create this

bead diameter:

COMPONENT LIST:

Please check that all components are included and not damaged by shipping. If you have missing or damaged

components, STOP and call Customer Service at 1-877-377-4674 before returning the kit.

2. LONG FRAME SECTIONS

PS1 & PT1 Models have TWO 61” Sections PS2 & PT2 Models have FOUR 30.5” Sections

Summary of content (4 pages)

PAGE 1
The Energy Guardian® Pulldown Ladder Cover Installation Instructions Models: PS1, PS2, PT1 & PT2 COMPONENT LIST: Please check that all components are included and not damaged by shipping. If you have missing or damaged components, STOP and call Customer Service at 1-877-377-4674 before returning the kit. 1. LID PS1 & PTI Models have ONE LID PS2 & PT2 Models have TWO LID HALVES 2. LONG FRAME SECTIONS PS1 & PT1 Models have TWO 61” Sections 3. SHORT FRAME SECTION (x2) 7.
PAGE 2
The Energy Guardian® Pulldown Ladder Cover Installation Instructions Please check that all components are included and not damaged by shipping. If you have missing or damaged components, STOP and call Customer Service at 1-877-377-4674 before returning the kit. LID and FRAME ASSEMBLY (PS2 and PT2 Models with 2-piece LIDS) NOTE: If your kit has a one-piece lid (PS1 and PT1 models) skip to HANDLE INSTALLATION section below Glue Pattern 1.
PAGE 3
FRAME ASSEMBLY 1. 2. 3. 4. Place LID down with lip of LID facing up. Label and HANDLES will be facing you (See Picture #8) Using LID as template, place 2 LONG FRAME SECTIONS on the LID.
PAGE 4
L-BRACKET ASSEMBLY 1. To ensure a snug fit of REMOVABLE SHORT FRAME SECTION, install L-BRACKET on outer side of both LONG FRAME SECTIONS even with REMOVABLE SHORT FRAME SECTION (See Picture #16) 2. Using SCREWS, secure L-BRACKET to floor of attic so vertical side of L-BRACKET is snug against the LONG FRAME SECTION (See Picture #17) 3. REMOVABLE SHORT FRAME SECTION should now fit snugly between the LONG FRAME SECTIONS 4.