Installation Guide

2
Optional Base Ring
Washer
Mounting Nut
Crosshead Screws
Ø 1- 1/2” fast water jet hole in
counter top
Ø 1-3/8” drill hole in counter top
Mounting Shank
Installation
Step 1
Step 2
Step 3
Hand Spray Supply Hose
Hand Spray Hose
Cold Supply
Hot Supply
Check Valve Housing
VERY IMPORTANT!
Step 5
Step 4
Step 6
Note: make sure the Hand Spray Hose
and Counterweight are free to extend
or retract and are not in conflict with
any plumbing components or items
under the Workstation.
H
C
1”
The Galley Tap comes with an
Optional Base Ring. It can be
installed with the Base Ring or
without it.
Insert all hoses and Mounting
Shank through the hole in counter
top.
On the underside of the counter
top, install the Washer and
Mounting Nut by slipping them
over the hoses and threading the
nut onto the Mounting Shank.
Tighten the Mounting Nut against
the counter top and tighten the
two screws so the Tap is secure.
Install the Counterweight onto the
Hand Spray Hose as shown.
Proper placement of the
Counterweights is critical for the
proper retraction of the spray hose.
Hand Spray Hose
Connect the Hand Spray Hose to the
Hand Spray Supply Hose in which
the Check Valve housing is fitted.
Before connecting the hot and cold
Supply Hoses, flush water supply
stops to clear any debris. Place a
bucket underneath the hoses and
carefully turn on the water. Run
water for 5 to 10 seconds.
Carefully position hot and cold
supplies so they will not interfere
with other hoses.
Connect the 3/8” Compression
Connections (Hot and Cold Supply
Hoses) to your hot and cold inlets.
Hoses are marked hot and cold.