Installation Instructions Stainless Steel Pull-down Kitchen Faucet THEGALLEY TAP ™ Made in Italy
Installation 1 Install the Optional Base Ring by slipping it over the hoses and onto the Mounting Shank. Optional Base Ring Mounting Shank 2 Optional Base Ring Insert all hoses and Mounting Shank through the hole in countertop. Minimum Ø 1-3/8” hole in Countertop 3 Stainless Steel Washer On the underside of the countertop, install the stainless steel Washer and Mounting Nut by slipping them over the hoses and threading the nut onto the Mounting Shank.
Installation 4 Hand Spray Hose Install the Counterweight onto the Hand Spray Hose as shown. 1” Important: Remove protective paper and stick rubber strips inside counterweight Counterweight 5 Hand Spray Supply Hose Connect the Hand Spray Hose to the Hand Spray Supply Hose on which the Check Valve housing is fitted.
Usage Faucet turns on by tilting handle out. Tilting angle is 24°. Handle rotates forward for temperature adjustment. When Handle is in upright position water temperature is fully cold. When Handle is rotated 90° forward water temperature is fully hot. Hand Spray pulls out up to 27” from the spout. Adjust Slide Switch down for spray flow or up for laminar flow.
Maintenance - Indoor Installation 1. Cartridge Replacement: a) Using an Allen Key, unthread Set Screw from handle. b) Unthread and remove Dome Cap and Cartridge Nut. c) Remove and replace Cartridge. Use the 2 pins on the bottom of the Cartridge to seat the Cartridge correctly. 2. Check Valve Replacement: a) Unthread Hose and Check Valve Housing. b) Remove and replace Check Valves by inserting them O-Ring side forward into Check Valve Housing. c) Re-assemble. 3.
Maintenance - Outdoor Installation 1. Cartridge Replacement: a) Using an Allen Key, unthread Set Screw from handle. b) Unthread and remove Dome Cap and Cartridge Nut. c) Remove and replace Cartridge. Use the 2 pins on the bottom of the Cartridge to seat the Cartridge correctly. 2. Check Valve Replacement: a) Unthread Hose and Check Valve Housing. b) Remove and replace Check Valves by inserting them O-Ring side forward into Check Valve Housing. c) Re-assemble. 3.
Care and Cleaning for The Galley Tap Finishes ABOUT OUR FINISHES: The Galley Tap is made of solid stainless steel. This finish has NO PROTECTIVE COATING on it. Stainless steel is by its material nature very tarnish-resistant, but by no means tarnish or stain proof. This finish will react to it’s environment over time. Cleaners that contain bleach may cause rust. Keep your Galley Tap wiped clean and dry, and use only a cleaner specifically made for stainless steel.
THE GALLEY TAP - LIMITED LIFETIME WARRANTY 1. GALLEY TAP LIMITED LIFETIME MECHANICAL WARRANTY – Seller provides a Limited Lifetime Mechanical Warranty. Seller warrants its products, installed in a residential application, to be free from manufacturing defects in materials and workmanship under normal usage for the useful life of the product. This Limited Lifetime Mechanical Warranty is subject to the warranty conditions and limitations as set forth below. 2.
CORPORATE HEADQUARTERS The Galley, LLC. 12626 South Memorial Drive Bixby, OK 74008 800.375.4255 thegalley.