Installation Sheet

INSTALLATION INSTRUCTIONS
Model # 72603
READ AND SAVE THESE INSTRUCTIONS
WARNI NG! SH UT POWE R O FF AT FUS E OR CI R C UI T BR EAK E R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the fuse box or circuit breaker box
and remove the old fixture, including the mounting
hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Attach circular strap (A) using outlet box screws (B) to
the outlet box (C) (not included). Make sure "GND"
facing outside. (Fig 1)
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig.2. Make
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the single bar using the
green screw (E) provided.
COMPLETING THE INSTALLATION (Fig. 1)
5. Align back plate (G) onto screws (D) and secure with
ball nut (H) (Fig 1).
6. To prevent moisture from entering the outlet box (C)
and causing a short, use clear silicone sealant to outline
the outside of fixture back plate (G) where it meets the
wall leaving a space at bottom to allow moisture a
means to escape. (Fig.3)
7. install 3*60W/E12/B bulb (no bulb included) in
accordance with the fixture specification
DO NOT EXCEED THE MAXIMUM WATTAGE
RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
8. At this point, hang the tiffany shade(I) onto the bracket
on the front of back plate(G), and secure with the ball
nut(J), and put the alum plate(K) to the back plate
bottom, and secure with the screws(L)
Your installation is now complete. Return power to the
outlet box and test the fixture.
Fig. 1
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
Fig. 3
Caulking
Backplate
SET A-021
-Circular Strap
-Ground Screw
-Mounting Screws(2)
Candle Sleeve #
CCV22079P-226
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT
ADÉQUATS.