Installation Sheet

PREPARI
NG
FOR INSTALLATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a
clear area. Take care not to misplace any small parts
necessary for installation.
3. Install all thread (G) into cross bar (E) and secure with hex
nut (C) and washer (D). Attach cross bar (E) (part #:A-012) to
outlet box (A) with outlet box screws (F) (size:8-32*1/2L).
Note: the side of cross bar (E) marked “GND” must face out.
4. Attach canopy loop (I) to all thread (G). Note: The length
of all thread (G) into the cross bar (E) may be adjusted if
necessary.
5. Adjust chain (L) to the desired length by removing unneeded
links. Attach one quick link (M) the end of chain (L) and then
to fixture loop (N). Pass lock collar (J) followed by canopy (H)
over the chain and allow them to rest carefully on the fixture
loop (N). Attach the other quick link (K) to the other end of
the chain and then to canopy loop (I).
6. Carefully pass fixture wires and bare ground wire through
chain (L), lock collar (J), canopy loop (I) and all thread (G).
CONNECTION THE WIRES (Fig. 2)
7. Connect the electrical wires as shown in Fig.2. Making sure
that all wire connectors (B) are secured. If your outlet box (A)
has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the cross bar (E) using the green
screw provided.
FINISHING THE INSTALLATION (Fig.1)
8. Slide canopy (H) over all thread (G) and secure with lock
collar (J).
9. Open the door (O). Install (3) three candelabra base bulbs up
to 60 watts or CFL or LED equivalent (not included) in
accordance with the fixtures specification. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!) (NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the outlet box and
test the fixture.
Candle Cover# CCV21066P-66
INSTALLATION INSTRUCTIONS
Model # 73204-66
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.
1
FIXTURE
WIRES
SMOOTH
FIG.2
HOUSE
WIRES
BLACK
(HOT)
FIXTURE
WIRES
RIBBED
HOUSE
WIRES
WHITE
(NEUTRAL)
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)
Notice:It is important to use proper chain pliers(not included)
To OPEN and CLOSE the chain included with this fixture.Do
not open them with other tools that may twist or stress the
chain links. It is important to use proper chain pliers like the
ones shown in the diagram.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
Part# A-012
Cross bar
Mounting screw (2)
Grounding screw(1)
Nipple and nut (1)
Chain part#
HCH2072-66