Installation Sheet

INSTALLATION INSTRUCTIONS
Model# 73248-748
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a clear area.
Take care not to misplace any small parts necessary for installation.
3. Thread all thread (M) into finial (I) until snug. Slide gasket (N) over all
thread (M) and insert assembly into top cover (F).
4. Place washer (O) over all thread (M) and tighten with nut (P).
5. Pull black, white and ground wires out of base cup (D).
CONNECTING THE WIRES (Fig. 2)
6. Connect electrical wires while supporting the lantern with wire connectors
(B). If your post (A) (not supplied) has a ground wire (green or bare
copper), connect the fixture ground wire to it. If not, consult your
electrician for proper grounding. After wires are connected, tuck them
carefully inside the base cup (D).
7. Align base cup (D) with post (A) and secure with mounting screws (C).
(Fig.1)
8. Install (3) three candelabra base bulbs (I) up to 60 Watts, or CFL or LED
equivalent (not included), in accordance with the fixture specification. (DO
NOT EXCEED THE MAXIMUM WATTAGE RATING) (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
9. Secure cover (F) to fixture frame (H) with screws (E) until tight.
10. This fixture is ETL listed for wet location applications.
Your installation is now complete. Return power to the outlet box and test the
fixture.
BAR E COP PER( GROUND)
Fig.2
FIXTURE
WIR ES
WHI TE
BLACK
(HO T)
WIR ES
HOU SE
GREEN O R
WHITE
(NEUTRA L)
WIRES
HOUSE
(GR OUND )
COP PER
BAR E
FIX TURE
WIR ES
BLA CK
WIR ES
FIX TURE
GRE EN OR
HOU SE
WIRES
“CAUTION-RISK OF FIRE CONSULT A QUALIFIED
ELECTRICIAN TO ENSURE CORRECT BRANCH
CIRCUIT CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES
CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS.
Fig. 1
Candle cover (3) (Part#CCV21054P-871)