Installation Sheet

INSTALLATION INSTRUCTIONS
For 8106-A138 (Rev. 05/06/2011)
READ AND SAVE THESE INSTRUCTIONS
WAR NI NG ! SH U T PO W ER OFF AT F USE OR CIR CU I T BRE AK ER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Pull the black, white and ground wires out of Post (C).
4. Next, connect electrical wires while supporting the
lantern as shown in (Fig.2). If your outlet has a ground
wire (green or bare copper), connect the fixture ground
wire to it. If not, consult your electrician for proper
grounding. After wires are connected, tuck them
carefully inside the post. Align the lantern with post and
secure bottom assembly (A) with Screws (B) (Fig.1 &
2).
5. Install the 1*60W A15 (not included) in accordance with
the fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-934E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
A
B
C