Installation Sheet

ManualsBrandsThe Great Outdoors ManualsLighting5 Light Lantern Pendant from the Stratford Hall Collection

INSTALLATION INSTRUCTIONS

Model # 8934

READ AND SAVE THESE INSTRUCTIONS

WARNING ! SHUT P O WER OFF AT FU SE O R CI RC UI T BRE AK E R.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

PREPARING FOR INSTALLATION (Fig.1)

1. Shut of the power at the circuit breaker and remove the old

fixture including the mounting hardware.

2. Thread nipple (I) into loop (D) until snug.

3. Thread other end of nipple (I) into the crossbar (H) until snug

and secure with lock washer (G) and hex nut (F). Note the

length of nipple (I) into crossbar (H) may be adjusted.

4. Attach the crossbar assembly to the ceiling outlet box with

screws (C).

HANGING THE FIXTURE (Fig.1)

5. Determine the desired hanging height and remove the excess

chain with proper chain pliers to avoid damaging the finish.

6. Open one end of the chain and connect it to the fixture chain

loop (L) and close the link. Thread the wire carefully through

the chain links.

7. Place lock ring (K) followed by canopy (J) over the chain and

allow them to carefully rest on the fixture body.

8. Open the other end of the chain and attach it to chain loop (D)

and close the link.

9. Feed the wires through loop (D), and nipple (I).

CONNECTING THE WIRES (Fig.3)

10. Connect the electrical wires as shown in Fig. 2, making sure

that all wire connectors are secured. If your outlet has a ground

wire (green or bare copper), connect the fixture’s ground wire

to it. Otherwise, connect the fixture’s ground wire directly to the

crossbar using the green screw provided. Tuck the wire

connections neatly into the junction box.

FINISHING THE INSTALLATION (Fig. 1)

11. Raise the canopy (J) to the ceiling and secure with lock ring

(K).

12. Install the bulb(s) type B/E12 candelabra base bulbs (not

included) in accordance with the fixture’s specification. (DO

NOT EXCEED THE MAXIMUM WATTAGE RATING!!) (NE

PAS DEPASSER LA PUISSANCE NOMINALE

MAXIMALE!)

13. Attach cage (M) to the top cover with screws (N).

Your installation is now complete. Return power to the junction box

and test the fixture.

Note: Illustration (Fig. 1) on this manual is for installation

purposes only. It may or may not be identical to the

fixture purchased.

Fig. 1

BARE COPPER(GROUND)

Fig.2

FIXTURE

WIRES

WHITE

BLACK

(HOT)

WIRES

HOUSE

GREEN OR

WHITE

(NEUTRAL)

WIRES

HOUSE

(GROUND)

COPPER

BARE

FIXTURE

WIRES

BLACK

WIRES

FIXTURE

GREEN OR

HOUSE

WIRES

“CAUTION-RISK OF FIRE CONSULT A

QUALIFIED ELECTRICIAN TO ENSURE

CORRECT BRANCH CIRCUIT CONDUCTOR”

ATTENTION – RISQUE D’INCENDIE, CONSULTER

UN ÉLECTRICIEN QUALIFIÉ POUR VOUS

ASSURER QUE LES CONDUCTEURS DE LA

DÉRIVATION SONT ADÉQUATS.

Notice:It is important to use proper chain pliers(not included)

To OPEN and CLOSE the chain included with this fixture.Do

not open them with other tools that may twist or stress the

chain links. It is important to use proper chain pliers like the

ones shown in the diagram.

U.S. Patent: D438,660

This product is protected by United

States Federal and/or State Law,

including Patent and/or Copyright laws.