Instructions / Assembly

1/4”
dia.
6mm
Phillips
screwdriver
Pencil
TOOLS REQUIRED
Electric drill
HARDWARE INCLUDED
C- Finials
x2
A- Outer Rod
x2
B- Inner Rod
x1
D- Brackets
x3
G- Wall anchor
x6
F- Mounting screw
x6
E- Set Screw
x6
Assembly for long rod configuration.
1
Unscrew the nial (C) from the inner rod (B) (the rod
that is smaller in diameter).
Screw nial (C) into the additional outer rod (A).
Assembly for short rod configuration.
1.2
Screw the additional nial (C) into the outer rod (A).
Save additional outer rod (A) for potential future use.
Insert both ends of the inner rod (B) into the two
outer rods (C) that have nials (C) installed.
Install
2
Assembly & Installation
1
Made in Thailand; Distributed by Mira Home Inc. Illinois USA
AC B
C
A
Use brackets (D) to mark desired mounting location.
Use drill to create pilot holes for attaching brackets to wall.
Once brackets (D) are mounted, adjust brackets to desired depth
and tighten with set screws (E).
Extend rod assembly to desired length, and place into bracket hooks.
Secure rod into both brackets (D) with set screw (E)
A CB
C C
A AB
C
A B
C C
A AB
A
C
A
A CBC
D
WOODDRYWALL
If installing into drywall
Based on the pre-drilled pilot holes, drive the drywall anchor (G)
into the wall using a Phillips screwdriver until ush with the wall.
Align the mounting brackets (D) with the drywall anchor (G) and
secure with the mounting screws (F).
If installing into wood stud
Align the mounting brackets (G) with pilot holes and secure with
the mounting screws (F).
GD
F
D
F
D
E
This product is designed for years of trouble-free performance. Keep it looking
new by doing the following:
Clean periodically with a soft cloth.
Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the nish
and void your warranty.
Care and Cleaning
D
E