Instructions / Assembly

UPPER JAMB
FRENCH DOOR UPPER JAMB
You will need to repeat the same process as above for the left and right sides of the upper jamb.
Upper Jamb (French Door)
NOTICE: HINGE TEMPLATES ARE NEEDED FOR HARDWOODS ONLY
Hinges on Right
Hinges on Left
A
Place the template for your desired swing conguration onto the upper jamb. Drill the spots where the screws for the hinges will be located. For
an out-swing conguration you will also need to drill through the entire upper jamb for the hinge pin to be able to pass through.
Paint Grade doors come with the Lower/UpperJamb pre-drilled. To
install the hinges, locate the side with the decal on it and ip it 180
degrees.
PAINT GRADE WITH PRE-DRILLED HOLES
Lower Jamb (Threshold) & Upper Jamb
180˚
Use a nail or similar object to pop out the last
remaining wood until the hole is unblocked.
NOTE: Although not
required, you may use some
small nish nails in addition
to the glue to help secure
the face frame.
Long Side
Short Side
Top
Bottom
MurphyDoor.com888-458-5911
G
(
6
)
5
Fastening Face Frame
Make sure that all dowel
holes are facing the front of
the door.
6
Hinge Templates