Specifications

3
Installation Instructions for Round Glass Guards (4 panels)
2
 Continue to install glass panels one at a
time in the same procedure as step one
until all four are in place.
 Once all four glass panels and top
brackets are in place, finish securely
tightening all 8 of the set screws holding
the glass together.
 Loosen set-screws in TOP BRACKET and
slide two curved glass panels into it.
 Ensure small silicone pad is in place on tip
of set screws. Never secure screws with
only the metal screw directly against the
glass. Overtightening may break glass!
 Tighten set screw until snug. Do not
tighten all the way until all four brackets
are on.
1
Top Bracket
3
 Continue by installing the BOTTOM
BRACKETS to the assembly and tightening
the set screws in the same manner as the
top brackets in previous steps.
 Remember to not overtighten screws and
be sure silicone pad is adhered to set screw.
Bottom Brackets
4
 Carefully, using two people, flip fully
assembled glass guard over and place on fire
pit centered around burner.
WARNING: Always perform assembly on a
soft, non-abrasive surface. Two people are
recommended for assembly and installation!
HINT: For rectangular, square and round
burners it is recommended to assemble guard
upside down and flip over after it is fully
assembled.
HOT GLASS WILL CAUSE
BURNS
DO NOT TOUCH GLASS
UNTIL COOLED
NEVER ALLOW CHILDREN
TO TOUCH GLASS