Specifications

5
A
C
Top bracket
Bottom bracket
Installation Instructions for L-Shaped Glass Guards
1
 Loosen set-screws in top and bottom corner
brackets and slide a short and long piece of
glass into it.
 Ensure small silicone pad is in place on tip of
set screws, never secure with metal screw
directly against glass. Over-tightening may
break glass.
 Tighten set screw until snug.
2
 Install corner brackets at
ends of glass and tighten set
screws.
A
A
B
B
C
C
5
 Slide final glass panel into place and ensure
all set-screws are tightened securely (do not
over tighten).
 With the help of one or two other people,
very carefully lift the glass guard up onto
the fire pit top and center on the burner
Glass Panel Key:
A: 14-1/2” L
B: 26-5/8” L
C: 41-3/4” L
4
A
B
C
B
C
A
C
3
A
C
B
C
 Continue by adding
panels B and C to the
assembly using the same
procedure as step one.
 Continue by adding panel B to assembly.
WARNING: Always perform assembly on a
soft, non-abrasive surface. Two people are
recommended for assembly and installation!
HOT GLASS WILL CAUSE
BURNS
DO NOT TOUCH GLASS
UNTIL COOLED
NEVER ALLOW CHILDREN
TO TOUCH GLASS