Instructions / Assembly

Each RAQ comes with pre drilled locaons for the in-

verters which allows for a multude of spacing adjust-

ments for cord management. Simply install inverter

with the T23 bolt provided. This bolt can be moved to

any predrilled locaon in the main rail. Once place-

ment is established set bolt but do not ghten. Slide

the inverter under the bolt, then ghten the bolt to

hold the inverter in place, the inverter may be posi-

oned on either side of the rail . Connect inverter ca-

bles to inverters according to manufacture suggesons.

A zip e is also included for cable management to be run down inside of C

Channel.

Once the anchor foot has been properly bolted to

the roof raers water protecon or roof ashing

can be placed. Unlike the majority of other rack-

ing systems, The RAQ, uses a Mechanical method

of water proong, not a chemical protecon.

Leveling the racking for mulple units in a row usual-

ly requires the installer to view the array from the

ground to determine if it is level based on aesthecs.

Please use a tape measure, string line, and a discern-

ing pair of eyes to make certain the array looks good

from every angle.

Begin by inserng the ashing under the shingle line

above the anchor foot locaon. Connue to rotate

the ashing under the shingle line unl it is fully seat-

ed over the anchor foot. Once ashing is seated over

the anchor base bend the tabs to secure the ashing

around the anchor foot. If you have a second row

below be sure there is proper spacing between rows,

(generally 27” when using the standard 60 cell panel)

Once the raer locaon is determined based on your

installaon layout conguraon predrilled holes

should be made with the 4 1/2” drill bit in the loca-

on where anchor bases will be installed into roof

raers. Note: Anchor bases may need addional ad-

justments o the rail before they line up with raers.

Start from the top work your way to the right, then

below. If you have a second row below be sure there

is proper spacing between rows, (generally 27” when

using the standard 60 cell panel)

To adjust leveling simply locate the anchor base that

need adjusng and modify anchor base ll it is ush

with the roof surface.

Note: Occasionally, one side of the installaon may be

more visible

Next prepare PV ‘s to be installed on leveled racking