Instructions / Assembly

Once aached, set PV down and center. Keep in mind:

The start bracket panel clamps must be adjusted uni-

formly; they allow for 3” of variance, determined by in-

stallaon conguraon. Secure upper and lower panel

clamps on the le side ONLY. To secure the # 1 PV mod-

ule, use the ½” socket on the top panel clamp, start by

securing the panel clamp on the start bracket side( le).

Then slide the panel clamps from the right side to the le

thus aligning the panel clamp over the frame of the mod-

ule. Only secure the panel clamps on the frame of PV

module.

Starng from the top row, from le to right, place the

#1 PV module in the portrait posion and place the

module onto the 1st RAQ unit (under panel clamps on

start brackets ) and hold up on right side to aach PV

to inverter cables.

Leveling the solar array for mulple units in a row re-

quires the installer to view the array from the ground to

determine if it is level; based on aesthecs. Visual exami-

naon aer PV’s installed adjustments made based on

installers eye to judge what anchors need to be adjusted.

Occasionally, one side of the array may be more visible

from the ground or even from a second-story window.

Connue using tape measure, string line, and a discern-

ing pair of eyes to make certain the array

looks good from every angle.

Before securing the next set of panel clamps onto 1st

PV bring in PV module # 2 onto the next RAQ unit to

the right. Install just like #1; by seng and lng le

side of PV in portrait posion under panel clamps,

aach PV to inverter and set down. Before securing #

2 PV to RAQ be sure it is ush and level with #1 PV.

Then secure the 1 & 2 PV module by securing the next

set of panel clamps upper rst, then lower clamp on

panel. Repeat for up to 18 panels before needing to