Third Party Verification Claim

PCT90190
ENVIROCRON® Powder Coat
Available in a wide range of colors and
glosses
Low cure capabilities
Exterior durability
Good chemical resistance
VOCs are essentially zero
UL Approved
Highlights
Product Features
PPG’s Enviracryl® and Envirocron®
powder coatings are aesthetically pleasing,
produce a durable uniform finish and can
be custom formulated with finishes from
high gloss to low gloss, and in a variety of
textures.
PPG’s “World Class” Polyester Powder
Coatings provide a combination of good
physical and chemical resistance
properties. This extensive line of Polyester
Powders is manufactured to meet the
increasing requirement demands of the
appliance and industrial markets. These
sophisticated Polyesters are the solution to
your smoothness, low-bake, durability and
physical property requirements. An
unsurpassed application development
program enables consistently friendly use
on a variety of substrates.
Black Texture
100% (5B Pass)
H - 2H Pencil (Eagle)
1/8'' Mandrel
- No Cracking
Adhesion
Hardness
Color
Impact Resistance
Conical Mandrel
__________
ASTM D-3359
ASTM D-3363
ASTM D-2794
ASTM D-522
Property
Test Method
Value
80 In.-lbs. Direct
80 In.-lbs. Reverse
ASTM D-523
Gloss
1000 Hrs. Pass
<1/8'' Scribe Creep
- No Blisters
Salt Spray
ASTM B-117
1000 Hrs. Pass
<1/16'' Scribe Creep
- No Blisters
Humidity
ASTM D-1735
Technical Properties
Electrostatic Spray
See Cure Curve PCT-045
Essentially Zero
Recommended Bake:
VOC:
Shelf Life from Date of
Manufacture:
PPG recommends that all material be used in FIFO order (first in - first out).
Materials that exceed the recommended shelf life should be tested prior to use.
Application Data
80 °F Maximum - 6 Months
12 Minutes at 300 °F Metal Temperature
Film Properties were determined using 1.5 - 2.5 mils powder film over iron
phosphated, chrome rinse pretreated, 22 gauge, unpolished cold rolled steel test
panels.
Application Type:
139 Sq. Ft. per pound at 1.0 mil
Theoretical Coverage:
1.38 ± .05
Specific Gravity:
0.0 - 5.0 @ 60°
11/17/2016
ENVIROCRON and the PPG logo are registered trademarks of PPG Industries, Inc.
* Statements and methods described herein are based upon the best information and practices known to PPG Industries, Inc. (“PPG”). Any statements or methods mentioned herein are general
suggestions only and are not to be construed as representations or warranties as to safety, performance, or results. Since the suitability and performance of the product is highly dependent on the
product user’s processes, operations, and numerous other user-determined conditions, the user is solely responsible for, and assumes all responsibility, risk and liability arising from, the determination
of whether the product is suitable for the user’s purposes, including without limitation substrate, application process, pasteurization and/or processing, and end use. No testing, suggestions or data
offered by PPG to the user shall relieve the user of this responsibility. PPG does not warrant freedom from patent infringement in the use of any formula or process set forth herein. Continuous
improvements in coatings technology may cause future technical data to vary from what is in this bulletin. Contact your PPG representative for the most up to date information.
1
PPG Industries 19699 Progress Drive Strongsville, OH 44149 800-450-2652 www.ppgindustrialcoatings.com [e-mail]