User manual

Attach the included antennas to the rear panel of the transmitter. To improve the transmission
quality and to adapt to the spatial conditions they are rotatable and swivelling.
In case the space provided on the device for direct assembly of the antennas is not sucient,
for example because the space on the rack is narrow, you can use the optionally available
coaxial cable to assemble the antennas separately from the device. For larger combinations
with up to four receivers, an antenna distributor is optionally available.
Connect one of the audio outputs of the receiver to your mixer or your amplier. Ensure that
only one of the two outputs is ever used at a time, because faults might occur otherwise.
4.3 Transmitter
Unscrew the bottom housing section of the hand-held microphone. Insert the batteries. Pay
attention to the correct location of the poles. The correct arrangement of the batteries is indi‐
cated with symbols in the battery compartment. Close the battery compartment, screw the
bottom housing section back on, and switch the transmitter on.
Attaching the antennas
Connecting audio and starting
up
Inserting batteries into the
receiver
Installation and operation
UHF wireless system
18