User manual

1. Open the transmitter to expose the infra red sensor.
2. Press [ADL]. The [IR] display blinks.
3. Hold the infrared sensor of the transmitter near the infrared interface of the receiver
within ten seconds.
4. When synchronization has been successfully completed, the [IR] display stops blinking.
ð
After three seconds, the display shows the default state again.
In case of model versions for the 1.8 GHz range, you can set the output level directly with the
arrow buttons.
In case of other model versions, proceed as follows:
1. Hold down [SET] until the [AF] area blinks on the display.
2. Use the arrow buttons to set the desired value. The current value is shown on the left
side of the display.
3. Press [SET] to conrm the selection.
ð
After three seconds, the display shows the default state again.
Synchronizing transmitter and
receiver
Set the output level.
Operating
UHF wireless system
32