User manual

If you don't wish to synchronize the transmitter with the receiver using the infra red interface,
you can set the transmitting frequency manually in the congurable frequency group (user
bank).
1. Keep pressing [SET] until the value in the [GP] eld blinks on the display.
2. Use [SEL] to select the frequency group.
Press [SET] to conrm the selection.
ð
The number in the [CH] eld blinks.
3. Use [SEL] to select a channel within the set frequency group.
If you have selected frequency group "U", you can use [SEL] to set the frequency directly.
First set the value before the decimal point, and press [SET]. Then set the value after the
decimal point.
Press [SET] to conrm the selection.
ð
After a few seconds, the display shows the default state again.
Select frequency
Operating
free solo HT
35