User manual

ð
The display shows that the receiver is being adjusted to the new frequency. After a
few seconds, the display shows the normal sate again.
1. Open the transmitter to expose the infra red sensor.
2. Press [ADL]. The [IR] display blinks.
3. Hold the infrared sensor of the transmitter near the infrared interface of the receiver
within ten seconds.
4. When synchronization has been successfully completed, the [IR] display stops blinking.
ð
After three seconds, the display shows the default state again.
Use the arrow buttons to adjust the output level.
Synchronizing transmitter and
receiver
Setting the output level
Operating
free solo PT 1.8 GHz
33