User manual

1. Open the transmitter to expose the infra red sensor.
2. Press [ADL]. The [IR] display blinks.
3. Hold the infrared sensor of the transmitter near the infrared interface of the receiver
within ten seconds.
4. When synchronization has been successfully completed, the [IR] display stops blinking.
ð
After three seconds, the display shows the default state again.
1. Hold down [SET] until the [SQ] area blinks on the display.
2. Use the arrow buttons to set the desired value. The current value is shown on the right
side of the display.
3. Press [SET] to conrm the selection.
ð
After three seconds, the display shows the default state again.
Synchronizing transmitter and
receiver
Setting squelch
Operating
free solo Twin HT free solo Twin PT free solo Twin HTPT
39