User manual

6.3 Bodypack transmitter
The keys for operating the device are located under the ap on the front side.
If you don't wish to synchronize the transmitter with the receiver using the infra red interface,
you can set the transmitting frequency manually in the congurable frequency group (user
bank).
1. Keep pressing [SET] until the value in the [GP] eld blinks on the display.
2. Use the arrow keys to select the frequency group.
Press [SET] to conrm the selection.
ð
The number in the [CH] eld blinks.
3. Use the arrow keys to select a channel within the set frequency group.
If you have selected frequency group "U", you can use the arrow keys to set the fre‐
quency directly. First set the value before the decimal point, and press [SET]. Then set the
value after the decimal point.
Press [SET] to conrm the selection.
ð
After a few seconds, the display shows the normal state again.
Select frequency
Operating
free solo Twin HT free solo Twin PT free solo Twin HTPT
45