User manual

6.2 Handheld microphone
The keys for operating the device are accessible if you unscrew the bottom housing section.
If you don't wish to synchronize the transmitter with the receiver using the infra red interface,
you can set the transmitting frequency manually in the congurable frequency group (user
bank).
1. Keep pressing [SET] until the value in the [GP] eld blinks on the display.
2. Use [SEL] to select the frequency group.
Press [SET] to conrm the selection.
ð
The number in the [CH] eld blinks.
3. Use [SEL] to select a channel within the set frequency group.
If you have selected frequency group "U", you can use [SEL] to set the frequency directly.
First set the value before the decimal point, and press [SET]. Then set the value after the
decimal point.
Press [SET] to conrm the selection.
ð
After a few seconds, the display shows the normal state again.
Select frequency
Operating
UHF wireless system
42