User manual
Table Of Contents
1.
Enter the parameter setup mode and press [/MODE] until the display shows ‘CH-ID’ .
2.
Press [/ACT/SET] until the channel number (left value) is blinking.
3.
During blinking, press [/ACT/SET] until the desired channel number is displayed.
4.
Press [/MODE] to save the value.
With the channel selection you can select the channel with less interferences.
The ID adjustable in addition to the channel increases the transmission reliability.
1.
Enter the parameter setup mode and press [/MODE] until the display shows ‘CH-ID’ .
2.
Press [/ACT/SET] once, then press [/MODE] once.
ð
The ID-number is blinking.
3.
During blinking, press [/ACT/SET] until the desired value is displayed.
4.
Press [/MODE] to save the value.
Select channel
ID selecting
Operating
wireless system
26