User manual

1. Call up the parameter setup mode.
2. Turn on the transmitter and point it directly at the infrared interface of the receiver. The
distance between the devices must not exceed 10 cm.
3.
Press [/ACT/SET].
ð
The two devices are synchronized. All settings made are transferred automatically.
Once the synchronization is complete, the display will return to the initial state, indi‐
cating the level of the radio signal and the volume.
If the synchronization has failed, the message ‘FAIL’ appears. In this case, hold the
transmitter closer to the receiver and restart the synchronization.
Synchronizing transmitter and
receiver
Operating
wireless system
30