User manual

Press the [SET],button repeatedly until the ‘GROUP’ field (frequency group) flashes in the dis-
play. Use the or buttons to increase or decrease the indicated value by one. When the
desired value is shown press the [SET] button to confirm the setting and proceed to the next
menu item. Press [ESC] to confirm the setting and exit the menu.
Press the [SET],button repeatedly until the ‘CHANNEL’ field flashes in the display. Use the or
buttons to increase or decrease the indicated value by one. When the desired value is shown
press the [SET] button to confirm the setting and proceed to the next menu item. Press [ESC] to
confirm the setting and exit the menu.
In the lower area, the display shows the used transmission frequency in MHz, that is assigned
to the set combination of frequency group and channel (
Ä
Chapter 8.2 ‘Frequency charts’
on page 24).
Transmitter and receiver must be set to the same combination of frequency group
and channel. If you use multiple wireless systems from this device family, for best
results you should assign all systems to the same frequency group, but give each
system a different channel.
Selecting frequency group and
channel
Operation
UHF receiver
18