User manual

To synchronise the frequency via the infra-red interface with the receiver, open the battery

compartment cover on the receiver and place the [IR] symbol on the receiver near the [IR]

symbol on the transmitter.

Press [SET] to open the menu. Use the [+] and [–] keys and select ‘IR’ . The eld ‘IR’ in the

bottom line of the display ashes. Conrm with [SET]. The display shows ‘IR -- -- --’ . The fre‐

quency set on the transmitter is transferred to the receiver. This process can take up to ten sec‐

onds. After synchronising the frequency, the menu closes automatically.

The displays on the transmitter and receiver show the same transmission frequency in MHz.

Press [SET] to open the menu. Use the [+] and [–] keys and select ‘MODE’ . The eld ‘MODE’

ashes in the display. Conrm with [SET]. Use the [+] and [–] keys to switch between mono and

stereo mode. When the desired mode is shown press [SET] to conrm the setting and exit the

menu.

Press [SET] to open the menu. Use the [+] and [–] keys and select ‘RF’ . The eld ‘RF’ ashes in

the display. Conrm with [SET]. Use the [+] and [–] keys to select the required transmitter

power ‘10mW’ or ‘50mW’ . When the desired value is shown press [SET] to conrm the setting

and exit the menu.

Synchronising the frequency

with the receiver

Selecting the operating mode

Selecting the transmitter power

Operating

UHF wireless system