User manual

Press simultaneously on the two side closures on the battery compartment, pull it gently

downwards and then fold it completely up. Insert the batteries. Pay attention to the correct

location of the poles.

Fold the battery compartment closed until it engages.

4.4 Taking system in operation

1. Ensure that the transmitter and receiver are switched o. The display on the transmitter

is dark; on the receiver, the main switch / volume control is in the "–" position.

2. Attach the receiver with the clip to your belt or guitar strap.

3. Carefully insert the ear phones into the ear canal, note the markings ‘L’ and ‘R’ for the left

and right side.

4. Connect the ear phones to the receiver.

5. Switch the transmitter on by pressing the main switch and the receiver by turning the

main switch / volume control and test the transmission. Make sure that transmitter and

receiver are set to the same frequency group and channel. If necessary, adjust the ampli‐

cation of the transmitter and receiver and the levels on your mixing console or your

amplier.

Installation

IEM 150