User manual

Table Of Contents

Make sure that the main switch / volume control (17) of the receiver is in ‘OFF’ position.

Simultaneously press on both snap-in locks of the battery compartment at the side and pull it

completely out of the receiver. Open the battery compartment lid by sliding the lid in arrow

direction and then folding it up. Insert the batteries respecting the correct polarity. Close the

battery compartment, the lid must snap-in firmly.

Rotate the battery compartment into the correct position to receiver; the side of the battery

compartment on which two conductor paths can be seen must point to the top side of the

receiver. Slide the battery compartment back into the receiver until it clicks into position.

Inserting batteries into the

receiver

Installation and starting up

IEM 200 R