Quick start guide
Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • info@thomann.de DocID: 234704_20.04.2021
EN
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
Dispose lithium batteries only in discharged condition. Remove replaceable lith-
ium batteries from the device before disposal. Protect used lithium batteries
from short circuits, for example by covering the poles with adhesive tape. Per-
manently installed lithium batteries must be disposed of together with the de-
vice. Please inquire about a suitable acceptance point.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your
local waste disposal facility
A detailed user manual of the Tour Guide TG 16 is available for download on the product page of our homepage www.thomann.de.
Transmitter 16 T for Tour Guide
Technical specications
Functional principle PLL synthesized control
Inputs 1 × 3.5 mm jack socket for microphone
Frequency of operation 863 MHz … 865 MHz
Max. transmission power 10 mW
Range (free eld) 50 m
Stability ±0,005 %
Frequency deviation ±48 kHz
Spurious emissions < –50 dBC
NF frequency response 40 Hz … 18 kHz
Battery Type Lithium-ion
Voltage 3.7 V
Operating time 14 h
Charging time in the device approx. 8 h
Dimensions (W × H × D) 54 mm × 99 mm × 17 mm
Weight 80 g
Ambient conditions Temperature range: 0 °C...40 °C
Relative humidity: 20 %...80 % (non-condensing)
Operating
Select channel
The display at the side of the device indicates the channel that is currently set. To ch-
ange the setting, press the button underneath the display until the decimal point on
the display ashes. If you briey press the button now, you can change the channel
number by one each time. The channel numbers are represented by the characters
„0“ … „9“, „A“ … „F“.
If you do not press the button for about six seconds, the device works with the cur-
rent settings. Transmitter and receiver must be set to the same channel.