User manual

6 Operating
6.1 Bodypack Transmitter TG 16 T
Thread the supplied band through the corresponding notches at the upper right corner of the
housing. If you do not want to use the built-in microphone, you can connect the supplied
earset microphone or another suitable microphone to the corresponding socket.
Make sure that the device is fully charged before using it.
Press [POWER] until the control LED lights up green. The device is now operational.
The display at the side of the device indicates the channel that is currently set. To change the
setting, press the button underneath the display until the decimal point on the display ashes.
If you briey press the button now, you can change the channel number by one each time. The
channel numbers are represented by the characters „0“ … „9“, „A“ … „F“. If you do not press
the button for about six seconds, the device works with the current settings. Transmitter and
receiver must be set to the same channel.
Preparing the unit
Turning the unit on
Select channel
Operating
tour guide system
36