User manual

44 [CR OUT L] | control room output for connecting ampliers or active speakers
45 [CR OUT R] | control room output for connecting ampliers or active speakers
+4 8 V
ONOFF
+48V
POWER
+18
+16
+13
+10
+6
+3
0
-3
-6
-1 0
-2 0
-3 0
PFL
L
(PFL)
R
-
8
MAX
CR & P H O N E S
dB
10
5
0
5
10
15
30
8
L
R
MI X
CR & P H O N E S
dB
10
5
0
5
10
15
30
8
V
Q
S
R
U
P
T
46 [+48V] LED | This LED lights up when the phantom power is on.
47
[+48V] switch | When this switch is in ON position, a phantom voltage of 48 V is present at the XLR sockets in the
mono channels for using condenser mics. If no condenser mics are used, the switch should be in the OFF position. The
phantom voltage must not be switched on if an unbalanced XLR cable is connected to one of the MIC inputs.
48 [POWER] | This LED lights up when the device is switched on.
49 [LEDs] | These LED chains indicate the level of the sum signal. Keep the level within a range below +18. The red LEDs
indicates overload. In this case, pull back the two master faders so that the red LEDs do not light up any more.
If the PFL button is pressed in one of the channels, the signal in this channel is displayed in the left LED chain, regard‐
less of the channel fader.
50 [PFL] | This LED lights up when in at least one of the channels the [PFL] button is pressed and thus the LED chains do
not display the sum signal.
51 [CR & PHONES] | rotary control to adjust the level at the outputs [CR OUT] and [PHONES]
52 [L MIX R] | master fader to adjust the sum level at the outputs [MAIN OUTPUT], [CR OUT] and [PHONES]
POWER
DA T E C O D E :
S E R IA L N o :
PIN 2 = HOT / PIN 3 = COLD
MAIN OUTPUTS
R L
ON
OFF
Thomann GmbH
Hans-Thomann- Str. 1
96138 B urgebrach
German y
Made in China
C A U T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
100-240V~50/60Hz
FUSE: T1.6AH250V
POWER CONSUMPTION: 40W
USE ONLY WITH A 250 V FUSE
W
Z\ [
X
Y
Rear panel
Connections and controls
14
xmix 1202 USB
Mixer