User manual

5 Connections and controls
1 [MIC] | balanced XLR mono input to connect a microphone
2 [LINE] | 1/4" phone input to connect a line level audio source (keyboards,
drum modules etc., balanced or unbalanced)
3 [80 Hz HPF] | high pass lter to attenuate rumble noise and other low fre‐
quency interferences
4 [GAIN] | rotary control to adjust the input level
5 [EQ] | 3-band EQ for treble [HIGH], mids [MID] and bass [LOW]
6 [AUX] | rotary control to adjust the signal portion to be sent to the output
[AUX SEND] to e.g. create a monitor mix
7 [PRE / POST] | When this switch is pressed, the signal portion set with the
[AUX] control is not aected by the channel fader ([PRE]). When the switch is
not pressed, the AUX signal is subject to the channel fader ([POST])
8 [FX] | rotary control to adjust the signal portion to be sent to the [FX SEND]
output
9 [PAN] | rotary control to arrange the channel signal within the stereo pan‐
orama R / L
10 [PFL] switch | When this switch is pressed, the channel signal is unaectedly
by the setting of the channel fader present at the outputs [PHONES] and
[CR OUT]. The switch does not aect the signal at the outputs [MAIN OUT]
and [REC OUT]
11 [PFL] LED | This LED lights on activated PFL function.
12 [PEAK] | The LED lights up on channel overload. If this happens, turn the con‐
trol [GAIN] to the left until this LED is extinguished.
13 The channel fader sets the strength of the channel signal in the overall
signal.
Mono channel strip
MIC 1
BAL/U NBAL
80Hz
HPF
MIC: -16
LINE:+10
-60 dB
-34 dB
+4
GAI N
LIN E
0
-10 +10
EQ
HIG H
12KHz
MID
1KHz
0
-10 +10
LO W
80Hz
0
-10 +10
AU X
0
-
8
+15
PRE
POST
FX
0
-
8
+15
PA N
L R
PFL
dB
10
5
0
5
10
15
30
8
1
PEA K
ö
#
%
$
&
'
(
)
*
+
,
-
.
Connections and controls
xmix 1402 USB
11
Mixer