SDS

Page 3/7
Safety Data Sheet
acc. to OSHA HCS
Printing date 12/14/2016 Reviewed on 11/08/2016Rev. 7
Trade name: LITOCHROM STARLIKE (comp B)
(Contd. of page 2)
43.2.12
*
7 Handling and storage
·
Handling:
·
Precautions for sa fe handling
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
·
Information about protection against explosions and fires:
No special measures required .
·
Conditions for safe storage , inclu ding any incompatibilities
·
Storage:
·
Requirements to be met by storerooms and receptacles:
Store in a cool location.
Store only in the original receptacle.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Store receptacle in a well ventilated area.
Keep receptacle tightly sea led.
Protect from heat and direct sunl ight.
·
Specific end u se(s)
No further relevant information available.
*
8 Exposure controls/personal protection
·
Additional informatio n about design of technical sy stems:
No further data; see item 7.
·
Control parameters
·
Components with limit values that require monitoring at th e workplac e:
The fo llowing co nstituent is the only constituent of the product which has a PEL, TLV or other recommended exposure
limit.
At this time, the o ther constituents have no known exposure limits.
CAS: 112-57-2 3,6,9-triazaundecamethylenediamine
WEEL Long-term value: 5 mg/m³
Skin; DSEN
·
Additional informatio n:
The lists that were valid during the creation were used as basis.
·
Exposure controls
·
Personal protective equipm ent:
·
General protective and hygienic measures:
Do not eat, drink, smoke or sniff while working.
Keep awa y from foodstuffs, beve rages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes and skin.
·
Breathing equipment:
Use suitable respiratory protective device in case of insufficient ventilation.
Short te r m filter device:
Filter B
·
Protection of hands:

Protective gloves
The glove material has to b e impermeable and resistant to the product/ the substance/ the preparati on.
Selection of the glove material on consideration of the penetration times, rates of diffusion and t he degradation
·
Material of gloves
The s election of the suit able gloves does not only depend on the material, but also on further marks of quality and
varies from manufacturer to manufacturer. As the product is a prep aration of seve ral substances, the resistance of
the glove material can not be calculated in advance and has therefore to be checked prior to the application.
·
Penetration time of glove material
The exact break throu gh time has to be found out by the manufacturer of the protective gloves and has to be
observed.
(Contd. on page 4)
US