INSTRUCTION MANUAL
ASSEMBLY GUIDE Congratulations, you are now the owner of a brand new home & office chair! To best enjoy the comfort of the chair, you have to put it together first! This assembly guide will take you through the assembly process. To make sure the assembly goes well, please follow the instructions, and especially the important safety information. It is possible to assemble the chair on your own, but it is recommended to have a second person to make it easier and safer.
Package List Without further ado, we kindly suggest you to list all parts needed for the chair first.
Assembly Instruction Step 1: (9)×2 Turn the Base (6) upside down, then insert Base Legs (7) one by one to Base. Use the Wrench (13) to screw Ten Bolts (9) into the pre-drilled screw holes to fix the Base and the Base Legs. 1 (6) (7) 2 (5) Step 2: Press the Casters (8) into the holes at the end of each Base Leg. Insert the Gas Lift (5) into the center hole of the Base.
3 Step 3: Turn the Seat Cushion (2) upside down and align the hole position of the Armrest 50% (3)*1(L)*1(R) with the pre-drilled hole position under the Seat Cushion. Attach the Armrest (3)*1(L)*1(R) to the Seat Cushion (2) with Six Bolts (12), using the Wrench (13). All bolts do not need to be tightened, they only need to be fixed in half. (12)×3 (12)×3 50% (2) (3) Note 1: The "Front" mark on the Armrests and the "Front" mark on the Seat Cushion should be in the same direction.
Step 5: 100% 5 100% tighten the Bolts (12) * 6 to fix the armrest. 6 Step 6: 100% 100% 100% tightened the Bolt (11)* 4 to fix the armrest and chair back.
Attach the Mechanism (4) to the Seat Cushion using Two Bolts (10) at the front and Two Bolts (10) at the back, tighten all the bolts with the Wrench (13). 8 7 (10)×4 Step 7: (4) (1) Step 8: Insert the slot on the back of the mechanism behind the cushion into the Gas Lift. CAUTION: Make sure all bolts and screws are fully tightened before using chair. Lubricate all moving parts and tighten all bolts/screws every 6 month or whenever needed.
Instructions For Use 1. Seat Height: Paddle-shaped lever on the right side To raise: While taking your weight off chair, lift lever up. To lower: While seated, lift lever up. * At the proper height, your feet should rest flat on the floor. 2. Operating the rocking function To let your chair tilt back, pull the control handle out. To stop your chair from tilting, sit forward, then push the control handle in.
Safety And Maintenance Do not stand on the chair, Do Not use the chair as a stepladder. Use this product for seating one person at a time. Do not use the chair unless all bolts and screws are firmly secured. Avoid contact with sharp objects to prevent puncturing the fabric. Every 6 months, check all bolts and screws to ensure they are tight. To clean, spot clean only using a damp towel and mild cleaner, first test on a small, unseen area of fabric. Chair weight limit not to exceed 250 lbs.
Limited Warranty The producer promises to repair or replace any chair that is found to be defective in material or workmanship within one(1) and year from the date of original purchase so long as you, the original purchaser, still owns it. This is your sole and exclusive remedy. This warranty is subject to the provisions below. EXCLUSIONS: This warranty does not apply and no other warranty applies to: Normal wear and tear, which are to be expected over the course of ownership.
