User Manual

3
Main Wing
(Lower)
15
d3 x D7mm Washer
PM3x16mm Screw
1
2
PA3x16mm Screw
1
Step 2. Install the right wing to the fuselage by inserting the wing
tube (now attached to the right wing) through the fuselage, then
install the left wing.
Step 3. Ma ke s ure the wings are r esti ng agains t th e
fuselage tigh tly. Locate the pre-d rill ed 2m m ho le
at t op o f left wing, and d rill along with 2mm drill bit
until i t passes through th e w i n g t u b e . A p p l y t h e
PA 3 x 1 6 m m s e l f - t a p p i n g s c r e w.
Note : It is recommended that the wing tube stays with
the left wing. Removal of the wings could be achieved
by removing the right wing machine screw, the right wing
then the left wing with wing tube. If removal of wing tube
from left wing is also required, it is recommended that
instead of applying self-tapping screw in step 3, you pre-
tap with M3 thread cutter and apply M3 machine screw.
14
Radio Equiment
Inst all and arran g e
the serv o as shown
in the diagra m .
Eye Screw
M2.5x8x25mm
HEAVY DUTY
SERVO HORN
PL4120800
Copper Tube
PM2x8mm
Heavy Duty
Clevis
Eye Screw
M2 Nut
Press down the
center 1/3 portion
Rudder Servo
Rudder Pullwire
Ø1x800mm
Heavy Duty
Clevis
Sponge
Front
PA3x16mm
d3 x D7mm
Washer
Left
Right
Top View
3
Step
Top View
2
Step
2.5mm
Wing Tube
Ø16x806mm
PM3x16mm
d3 x D7mm
Washer
≈295mm
Main Wing (Lower)
1
Step
≈10
2mm
P.10
Step1.Insert aluminum wing tube
(Ø16x806mm)with the pre-drilled
hole end into the right wing(lower).
Align the lines marked at the wing
root and wing tube,then apply the
PM3X16mm machine screw through
the pre drilled hole on top of the
-
wing.(please confirm the alignment
of the hole by putting a 2.5mm diameter
rod through the pre-drilled wing hole
before applying the screw) The hole
on the wing tube is pre-threaded,do
not over tighten the PM3 screw,the
set up is for future removal of the wing.