Operation Manual

Continuous valve actuator CHEOPS control
theben
As of: Jul-11 (Subject to change without notice) Page 38 of 71
3.4.10 External interface
See also "External interface" Appendix
Table 20
Designation
Values
Meaning
Type of connected window
contact
Window open = contact closed,
Window open = contact open
Enables both NC and NO
contacts to be used
If several contacts are present,
these must be switched in
parallel
If several contacts are present,
these must be switched in
series
Transmission of window
state
No transmission
Only in case of change
at change and cyclically with
actual operating mode
Is the status of the connected
window contact to be sent to
the bus?
Same cycle time as for
sending current operating
mode
Type of connected
presence contact
Present = contact closed,
Present = contact open
Enables both NC and NO
contacts to be used
Transmission of presence
status
No transmission
Only in case of change
at change and cyclically with
actual operating mode
Is the status of the connected
presence contact to be sent to
the bus?
Same cycle time as for
sending current operating
mode