Operation Manual

Continuous valve actuator CHEOPS control
theben
As of: Jul-11 (Subject to change without notice) Page 65 of 71
6.2 Read-out error code
Important:
The error code was replaced (from 2008) by the calibration strategy code.
Up to 2008:
If the valve causes an error message and the LEDs flash as continuous light, Cheops generates
an error code.
This remains in the BCU memory and can (start-up/test) be read-out using the ETS software.
1. Select device in the project and click on Test / Device memory viewer menu item
2. Enter memory area 1FB, deselect RAM and EEPROM
3. Click the button