Operation Manual

Continuous valve actuator CHEOPS control
theben
As of: Jul-11 (Subject to change without notice) Page 68 of 71
6.4 Checking adapter ring
The maximum dimension between top edge of adapter ring and end of tappet is 4.7 mm.
If this dimension is over-run, an alternative adapter ring must be used.
Max. 4,7mm
6.5 Reading the software version number
Cheops displays the current software version via LEDs.
After reset, this is displayed as a binary number in three stages.
• Stage 1: Full display: All LEDs = ON
• Stage 2: LED 0 is ON and the upper 4 Bits are shown
(= Hi-Nibble, value: see table)
• Stage 3: LED 0 is ON and the lower 4 Bits are displayed (= Lo-Nibble).
•
The values of the individual LEDs are displayed as follows
LEDs
Value
4
8 (=2
3
)
3
4 (=2
2
)
2
2 (=2
1
)
1
1 (=2
0
)
0
none
The number is produced from the sum of the values of the illuminated
LEDs 1..4.
LED 0 is not counted.