Manualshelf

Full Product Manual

ManualsBrandsTheraSauna ManualsKitchen4-Person Face to Face Infrared Health Sauna with MPS Touchview Control, Aspen Wood and 12 TheraMitter Heaters
6789101112131415
11
MPS TOUCHVIEW
TM
3.0 USER MANUAL
MPS CONTROL SCREEN
AUTO RUN SCREEN
The Autorun user buttons at the Home Screen are the main on/off switches for a pre-programmed sauna session. “AUTORUN
User 1 & 2” are programmed in the “AUTORUN SETUP AREA” at the “SETTINGS Screen.”
At the “Settings Screen” press User 1 or 2 icon at the Autorun setup area of the screen. Next, press the keyboard icon to enter
a name. Press the icon again to save the name. Here you can also program your TheraSauna® start time for each 7 days of the
week with the same or different starting time. You can only program one (1) start time per day in each Auto Run program. There
are (7) categories to be programmed (shown below) Press the category to set, beginning with Monday (the button will
highlight yellow).
1. THE DAY OF THE WEEK
2. USER NAME
3. DAY ENABLED
4. MODE
5. TEMPERATURE
6. TIME OF DAY
7. SESSION LENGTH
Next, set the “Mode” to either MPS or SpectraWave (If you choose MPS, REFER TO PAGE 10. Press “Setup MPS” to choose a
power setting for each TheraMitter® Bank.) Next, set the “Temperature & Time” for program to begin. Continue with “Session
Length”. (Do this for each day to be programmed). Next, for each programmed day, press each day and turn to “ON” by pressing
the “Day Enabled” button. This activates the day to turn on for the day already programmed. (The day buttons will turn that day
on/off at the User 1 and User 2 buttons). This feature allows the option to add/remove certain days from Auto Run program with-
out changing the program settings. Remember to press “Save” before exiting in order to save your program, or “Cancel” to
discard your settings.
PLEASE NOTE: EACH DAY MUST BE PROGRAMMED SEPARATELY. As you move from (Mon) to (Tues), Etc., the screen set-
tings will be retained for each day, and ready to program the next day’s settings. Save Button saves all your new settings. Cancel
Button discards your settings. Warning: You MUST press the SAVE button to retain the entire week’s settings.
Setting all TheraMitter Banks to 100% is the same as Quick Start Mode (page 5).
AUTO RUN