Full Product Manual

MPS TOUCHVIEW

3.0 USER MANUAL

GET TO KNOW THE HOME SCREEN, THIS IS THE MAIN SCREEN IN

WHICH YOU CAN DO ALMOST EVERYTHING FROM THIS HERE!

SELECTING YOUR SAUNA MODEL

This screen will be the first one you see if you reset the sauna (Help, Troubleshooting for more info) or you will see the Home Screen

(on page 5) if this is your initial start up.

When you turn on the MPS TouchView

3.0

Control and reset the sauna, tap the the arrows to select the model of Sauna you have

and press save. This will complete the reset up for your sauna model.

NOTE: IF YOU SAVE THE WRONG MODEL YOU CAN ALWAYS GO TO THE HELP MENU, SELECT TROUBLESHOOTING,

AND PRESS THE RED RESET BUTTON AND RESET NOW. Next you will see dialog boxes that will take you to the Home Screen.

Congratulations you will be ready to use your sauna!

IMPORTANT NOTES: For TheraSauna to be setup properly do not activate WI-FI or Bluetooth functions. This will void warranty due to update

and program interferences. The controller has been developed and programmed as a sauna control system device and not as a computer note

pad. MPS TouchView

3.0 should only be used to control your sauna. QCA Spas and TheraSauna are not responsible for any conflicts or

malfunctions as a result of WI-FI/Bluetooth operation.

Do not plug unit into wall receptacle until completely assembled and ready to start up the MPS TouchView

3.0 in the sauna. Then plug in and

start the TheraSauna 3.0 program icon in the MPS TouchView

3.0 controller. Wait for communication to be established between MPS

TouchView

3.0 controller and the System Power Supply, making sure no error message appears to “plug in USB Cable.” When communication

has been acquired this message will not appear.

Tap the “TheraSauna Program Icon” on the controller Home Screen. Press the “Start” button – If function is normal the Green “Quick Start”

button will turn red and read ”Starting” – the “updating session do not exit” icon will appear at top of screen next to light icon – after about

seonds the icon will say “Quick Start Active” & the “Starting” button will read “STOP”. (If error message persists, simply cut power to

the sauna, wait 30 seconds and reapply power to the sauna.Theramitters will now be active. You can now move unit back against the wall.

From time to time due to electrical fluctuation and other interference a message may appear to ”Plug in USB Cable”. In that case simply

cut power at the main circuit board in your house or at the wall outlet. After 30 seconds re-establish power and communication will be

restored to the MPS TouchView

3.0 System.

WELCOME SCREEN

PLEASE NOTE: BE SURE TO OPERATE YOUR SAUNA WITH DOOR OPEN FOR 1 HOUR BEFORE USING.