Manualshelf

Full Product Manual

ManualsBrandsTheraSauna ManualsKitchen4-Person Face to Face Infrared Health Sauna with MPS Touchview Control, Aspen Wood and 12 TheraMitter Heaters
12345678910
7
MPS TOUCHVIEW
TM
3.0 USER MANUAL
SETTING DATE AND TIME
Pressing the Date and Time button (on the Settings Screen) takes you the Date and Time screen, adjust each option
related to date and time within this screen. To return to the Thersauna Date and Time program screen, press the back
arrow on the bottom menu bar of the tablet. Please make sure you select your time zone if it is not already set to
your area.
IMPORTANT NOTES: For TheraSauna to be setup properly do not activate WI-FI or Bluetooth functions. This will void warranty due
to update and program interferences. The controller has been developed and programmed as a sauna control system device and not as a
computer note pad. MPS TouchView
TM
3.0 should only be used to control your sauna. QCA Spas and TheraSauna are not responsible for
any conflicts or malfunctions as a result of WI-FI/Bluetooth operation.
Do not plug unit into wall receptacle until completely assembled and ready to start up the MPS TouchView
TM
3.0 in the sauna. Then plug in
and start the TheraSauna 3.0 program icon in the MPS TouchView
TM
3.0 controller. Wait for communication to be established between MPS
TouchView
TM
3.0 controller and the System Power Supply, making sure no error message appears to “plug in USB Cable.” When communication
has been acquired this message will not appear.
Tap the “TheraSauna Program Icon” on the controller Home Screen. Press the “Start” button – If function is normal the Green “Quick Start”
button will turn red and read ”Starting” – the “updating session do not exit” icon will appear at top of screen next to light icon – after about 5
seconds the icon will say “Quick Start Active” & the “Starting” button will read “STOP”. (If error message persists, simply cut power to
the sauna, wait 30 seconds and reapply power to the sauna. TheraMitters will now be active. You can now move unit back against the wall.
From time to time due to electrical fluctuation and other interference a message may appear to ”Plug in USB Cable”. In that case
simply cut power at the main circuit board in your house or at the wall outlet. After 30 seconds re-establish power and communication
will be restored to the MPS TouchView
TM
3.0 System.
DATE & TIME SCREEN