Assembly & MPS Control Manual Owners Manual and Assembly for Model TS7754 Touch View control operations Opposite Facing TheraManual 6.1.
CONGRATULATIONS! Your recent purchase of a TheraSauna® is a step towards a lifetime of better health and well-being. Health and medical experts agree TheraSauna® is one of the finest products of its kind worldwide. We welcome you to the TheraSauna® family and wish you many years of enjoyment. Table of Contents Saunas…………………….…...2 Parts List……………….........3-5 Sauna Location…………..........6 Assembly Tips…………….......7 Assembly Instructions……....8-9 Electric Power…....……..…....10 MPS Control Instructions...
Before assembling your TheraSauna® please check the parts you have with the enclosed parts list. Parts List Figure 1 Figure 2 Sauna control box will face out. Face Up Bottom/Floor Back Wall Quantity 1 Quantity 1 Figure 3 Figure 4 Side Walls Quantity 1 Each Sauna walls have stickers designating “right or left” When installed, these panels will face into the sauna.
Figure 5 Figure 5 Front Wall Quantity 1 Finished side will face out. Outside Front Wall Inside Front Wall Figure 6 Figure 7 Front view Knob faces inside of TheraSauna® Right Bench Support Panel/Seat Roof Quantity 1 Quantity 1 Figure 8 Left and Right View Figure 7 Seat Quantity 1 Reversible bench, one side is contoured for sitting. The other side is flat for lying down. Serial number is on the flat side underneath of the bench.
Figure 10 Figure 11 Light Fixture Light Mounting Screw Quantity 1 Quantity 1 Figure 12 Figure 13 5/16 Hex Wrench Bolts Quantity 1 Quantity 14 Figure 14 Door Handle Quantity 1 5
SAUNA LOCATION The TheraSauna® should be installed only inside a home or other enclosed structure with a flat leveled floor and a 20 Amp dedicated outlet in close proximity. Saunas must be directly plugged into outlets, no extension cords should be used. Select a location that will be convenient for you and will provide you with maximum accessibility. Outside placement will void the warranty. WARNING! This unit is manufactured for indoor use only.
FOR YOUR SAFETY 1. Electrical and/or Light Receptacles shall not be installed inside the TheraSauna® room. 2. Do not add any locking or latching systems to the door of your TheraSauna®. Malfunction of which could cause entrapment inside the sauna. 3. The TheraSauna® comes with a sliding roof vent to provide proper ventilation to allow in fresh air if so desired. Keep vent closed when heating sauna. ASSEMBLY TIPS All assembly instructions are included with your TheraSauna®.
ASSEMBLY INSTRUCTIONS FOR THERASAUNA® 1. Place the base panel (Figure 1, page 3) on a solid flat surface with 5 supporting blocks down. Note: The two metal inserts will indicate the front of the base panel. 2. Stand back wall (Figure 2, page 3) on base with channeled edge up, make sure to center wall along back edge of base. Note: Base should extend out from each end of wall. 3. Stand left sidewall (Figure 3, page 3) with channeled edge up on base at a 90° angle to back wall.
8. Front edge of seat top (Figure 8, page 4) is finished. With finished edge toward you slide both left and right seat tops all the way to back wall so it rests on supports provided. Seat is reversible to your preference. Note: The seat cannot be reversed once the front wall is in place. The front walls must be removed if the seat needs to be reversed once the sauna is assembled. 9. Stand front wall (Figure 5, page 4) on base, with channeled edge up.
USE Always consult a physician before beginning a sauna program. You may wish to begin with shorter sessions, 10 – 20 minutes, in the TheraSauna® and work up to 30 – 60 minutes per session, as you feel more comfortable and familiar with the effects. Begin at a lower temperature setting and work up to one that is comfortable for you. ELECTRICAL POWER REQUIREMENTS TS7754 – 110V-125V – 20 Amp 60 Hz dedicated wall receptacle.
Micron Power Select TouchView Control Operations The screen is very touch sensitive. DO NOT press on the screen with a lot of pressure. Simply touch or tap on the screen with a finger. Don’t be afraid to touch the screen, you won’t hurt it! *NOTE: Touch screen has a 10 minute time out feature. If the screen hasn’t been touched in 10 minutes, it will return to Home Screen and the backlighting will dim. Just touch anywhere on the screen and it will light back up.
Starting From the Home Screen Light & Audio Icons In the upper right side of this screen and every other screen you will see there are these 2 icons. One icon for the light controls and the other icon for the audio controls. Pressing the plus or the minus signs will either brighten or dim the light. For the audio it either increases or decreases the volume. This also increases or decreases the loudness of the Beep you hear when a button is pressed.
Let’s Get Started From the HOME SCREEN, touch the SET UP pad. You now see several set up options. Let’s get started by setting your clock. With the clock being set up first, you can use your sauna shortly. We will return to the SET-UP screen later on. *NOTE: Whenever the SAVE pad is touched you will go to the HOME screen. To continue your set up options you must touch SET UP to re-enter the set up screen.
Set-Up Clock Setting The Clock From the HOME screen, touch the SET-UP pad. Now you are in the SET-UP screen, where you are able to set up various programs. Touch the SET-UP CLOCK pad. DAY OF WEEK Touch up or down arrows to adjust. HOUR Touch the + (plus) and – (minus) signs to adjust. Once the number hits 0 (zero) or 11 (eleven) you must reverse your buttons. AM or PM will change when you pass the 12pm hour. MINUTES Touch the + (plus) and – (minus) signs to adjust.
You are now ready to use your sauna. You can program your sauna for 7 days. Sauna should be set at 125 degrees and run for 60 minutes before initial sauna session. This only has to be done once. USE NOW This option if touched on the HOME screen will bring you to the above screen. You would touch this option if you are ready to use immediately. TEMP SET Touch the + (plus) or – (minus) signs to increase or decrease the temperature.
OFF Mode: “OFF” mode will run the sauna at the desired time and temperature, but the Theramitters™ will always operate at 100%. You will not be able to lower the Theramitters™ in this mode or make any changes to the sauna session. Running the sauna in “MPS” mode with all Theramitters™ at 100% will achieve the same effect as running the sauna in “OFF” mode. Important Note: “OFF” Mode is not a customizable mode and is only intended to be used as a singular mode.
IN USE Screen This screen is a graphic illustration on how your different zones are working. It shows current and set temperatures and elapsed time left. By touching the ADJUST pad you can re-adjust your time and temperature settings. When done adjusting, press the ZONES pad on the screen and your sauna graphic (shown above) will reappear. Touch the HOME pad on the screen and the sauna will shut off and you will return to the HOME screen.
Now that you have set your clock and have used your sauna, let’s return to the SETUP screen. Touch the SETUP pad on the HOME screen to return to the SETUP screen. Now you can finish setting up the various other programs. Remember, whenever you touch the SAVE pad you will return to the HOME screen. You must touch SETUP again to return to the SETUP screen.
MPS Setup Screen SET UP CLOCK See page 3. SET UP MPS (From Setup Screen) (MPS = Micron Power Select) (Screen shown above) On the left side of the screen, you should see a graphic image of your sauna. The circled numbers represent each heater zone in the sauna. These numbers will correspond with the zone numbers on the right side of the screen. To adjust the micron level of each zone from 100% (highest) to 7% (lowest) touch the + (plus) sign to increase, - (minus) sign to decrease.
PRE HEAT & HOLD PREHEAT – (From SETUP Screen) This option when touched on the screen will preheat your sauna to 100 degrees Fahrenheit if selected, and hold that temperature for as long as the PREHEAT mode is on. When you see this screen, the Preheat mode has already been activated and is on. To cancel PREHEAT, touch the HOME pad on the screen. Touching the START pad on the screen while in The PREHEAT screen will take you to the USE NOW screen and also cancel the PREHEAT program.
SET UP AUDIO SET UP AUDIO (From SETUP Screen) Touch this option on the screen and you will go to the AUDIO screen (shown above). In this screen, you will find 6 peaceful, relaxing sounds to help you get the full therapeutic session of your TheraSauna. Make your choice of sound and remember to touch SAVE on the screen to save your choice. Touching SAVE will return you to the HOME screen. When AUDIO sound is on, the sounds will play even when the sauna is off.
SET UP AUTO 1 & AUTO 2 Set Up Auto 1 & Auto 2 – (From SETUP Screen) In this screen option, you can program your TheraSauna® start times for each seven days of the week, with the same or different times. You can only program one (1) start time per day in each Auto Run program. On the left side of the screen you will see 5 categories to choose from. Touch the category you want to set beginning with the “Day:” Then use the + (plus) or – (minus) signs on the value pad to adjust.
TROUBLE SHOOTING 1. Heater will not heat. Solution: 1. Check the MPS settings to be sure that the heater is set higher than 7%. 2. Check plug in connection at main control box on top of the sauna. 3. Check the extension cords in the roof. 4. Check connections at the heater box. 2. Touch Screen turned black or locked up. Solution: 1. Unplug sauna for 20 seconds and plug back in. All your settings will be saved. 3. Error codes: Solution: Read and write down all the information.
once more and change “WAVE” to “MPS.” You can now adjust the Time & Temperature, press “START,” and run the sauna in “MPS” mode without receiving an error. If after reading this entire manual you require assistance, please call our Customer Service Department at (888) 729-7727. You must have your serial number, Date of Purchase and Place of Purchase information ready for quick reference. Our technicians cannot help you without this information.
HELPFUL TROUBLESHOOTING HINTS *CAUTION DISCONNECT POWER SUPPLY BEFORE SERVICING* PROBLEM CAUSE TIPS Sauna light not working Light not plugged Remove light mounting screw and light will come off the in wall. Check light plug to be sure it is plugged in securely. Sauna light not working Bad light bulb Check light bulb in separate light socket. OH message System has displayed on control overheated panel Assembly bolts will Floor not level not line up No service needed.
WOOD CHARACTERISTICS Each tree has its own characteristics that are unique to it alone. These features include differences in color and grain directions that are produced by nature in every tree. These variations create the beauty and style found in fine wood. Since these differences in texture and grain affect the final finish, it is impossible to guarantee an exact match in finish between any two pieces, even though identical finishing processes are applied.
HELPFUL HINTS FOR SAUNA USE Drink liquids prior to, during and after your sauna session. Water works just fine. Use the best quality water available to you. Eating a piece of fruit is helpful to replace potassium. The typical American diet can replace phosphorous which is lost through perspiration. Magnesium is replaceable through green leafy vegetables or supplementation. (Some facts about Gatorade: the “energy” Gatorade supplies to muscles is SUGAR. The “fluids” are water.
THERASAUNA® DISCLAIMER Disclaimer QCA Spas, Inc. (manufacturer of TheraSauna®) and its affiliates do not provide medical advice, education or treatment. The information contained in this manual is for general information purposes and is not intended to address individual medical conditions. Infrared heat may not be right for you and the information herein should not be relied upon in making decisions about your health. Always consult your physician for medical advice.
TheraSauna® Warranty Labor: One-year warranty on labor Controls: Three-year warranty on the controls. TheraMitters™: Lifetime warranty with a 50 dollar handling fee per incident. THIS UNIT IS MEANT FOR INDOOR USE ONLY. WARRANTY IS VOIDED IF THERASAUNA® IS PLACED IN AN OUTDOOR ENVIRONMENT. Limited warranty on TheraSauna® replacement parts. TheraSauna® warrants its products to be free from defects in material and workmanship for a period of one year from the date of purchase, except as noted above.
To receive your FREE gift for your sauna and to VALIDATE your sauna warranty, return the PREPAID registration card within THIRTY days of delivery. You will find your serial # located below the TheraSauna® bench area, on the left wall or the back wall. You must include your serial # on your warranty registration card in order to receive your free gift. You may also validate your warranty online at www.therasauna.
This symbol designates that these saunas are listed by Intertek Testing Services NA Inc. for use in the United States and Canada.
