Full Product Manual

15
You are now ready to use your sauna. You can program your sauna for 7 days.
Sauna should be set at 125 degrees and run for 60 minutes before initial sauna
session. This only has to be done once.
USE NOW
This option if touched on the HOME screen will bring you to the above screen. You
would touch this option if you are ready to use immediately.
TEMP SET
Touch the + (plus) or – (minus) signs to increase or decrease the temperature.
TIME SET
This option lets you set the amount of time you want your sauna session to last. Touch
the + (plus) or – (minus) signs to increase or decrease the length of time.
MODE
This option has 3 settings. The + (plus) and – (minus) signs allow you to select
WAVE, MPS, or OFF mode.
MPS Mode: Allows you to run the sauna with the Theramitters™ set at power
levels specifically selected by the user. To adjust the power level of each
emitter, go to the “SETUP” menu, then press “SETUP MPS.” You can now
adjust the power level of each emitter. Press “SAVE” and the computer will
remember your settings and use them when “MPS” mode is selected.
WAVE Mode: “WAVE” mode will automatically adjust the power level and
micron level of the Theramitters™ during the time the sauna is running. This is
a session that automatically cycles through different MPS levels to give the user
various levels of infrared.