Instructions / Assembly

9
8. Front edge of seat top (Figure 8, page 4) is
finished. With finished edge toward you slide both
left and right seat tops all the way to back wall so
it rests on supports provided. Seat is reversible to
your preference. Note: The seat cannot be reversed
once the front wall is in place. The front walls
must be removed if the seat needs to be reversed
once the sauna is assembled.
9. Stand front wall (Figure 5, page 4) on base, with
channeled edge up. Slide front wall into vertical
channel on side and insert six furniture bolts into
holes in both sidewalls into the front wall (do not
tighten). At this stage begin to tighten bolts
continuing around sauna. Tighten bolts securely.
10. Screw two furniture bolts (Figure 12, page 5) into
holes in threshold inside door opening. Note:
Some adjusting may be necessary to line up holes
in threshold and threaded receivers in base using
hex wrench provided.
11. Set roof (Figure 6, page 4) on sauna making sure
top trim extends down over walls all the way
around. If trim does not extend over walls all the
way around, rotate top ¼ turn.
12. Install light plug connector on light (Figure 10,
page 5) into connector coming out of front wall.
Screw securely to the wall with light mounting
screw (Figure 11, page 5). See instructions
included in light box.
13. All TheraSauna’s are equipped with an LED.
perimeter light system.
a. Locate the plug coming out of the roof panel
(110Volts). Plug into wall outlet.
b. To turn on the lights, wave your hand in
front of the motion detector located on the
top of the sauna by the left side of the door.
c. Wave your hand in front of the motion
detector to turn it off.
Fully Assembled TheraSauna.